Standard Horizon HX40E Manuel D'utilisation page 83

9.1.5 SCAN RESUME
This selection is used to select the time the HX40 waits after a transmission ends
before the radio starts to scan channels again. The default setting is 2 seconds.
Press and hold [ ENT/MENU ]  "CHANNEL SETUP"  "SCAN RESUME"
1.
2. Press the [▲] or [▼] key to select the de-
sired time. The resume time can be set to "1
sec" through "5 sec".
3. Press the [ENT/MENU] key to store the new
setting.
4. Press the [CLR/
9.1.6 MULTI WATCH
This selection is used to choose between "Dual Watch" and "Triple Watch".
Refer to section "8.10.1 Setting up the Multi Watch Operation" for details.
9.1.7 PRIORITY CH
This procedure may be used to designate a different priority channel when
priority scanning. By default, the radio priority channel is set to Channel 16.
Press and hold [ ENT/MENU ]  "CHANNEL SETUP"  "PRIORITY CH"
1.
2. Press the [▲] or [▼] key to select the de-
sired channel to be a priority.
3. Press the [ENT/MENU] key to store the new
setting.
4. Press the [CLR/
9.1.8 SUB CH
By default, the sub channel is set to Channel 9. This procedure allows the
radio to assign a different sub channel for instant access.
Press and hold [ ENT/MENU ]  "CHANNEL SETUP"  "SUB CH"
1.
2. Press the [▲] or [▼] key to select the de-
sired channel to be the sub channel.
3. Press the [ENT/MENU] key to store the new
setting.
4. Press the [CLR/
] key to return to radio operation.
] key to return to radio operation.
] key to return to radio operation.
Page 29