Standard Horizon HX40E Manuel D'utilisation page 82

9. MENU ( "SETUP" )
The HX40's Menu Mode allows enables a number of the HX40 operating pa-
rameters to be custom-configured.
Use the following procedure to activate and set The Menu Mode parameters:
1. Press and hold the [ENT/MENU] key.
2. Press the [▲] or [▼] key to select the desired menu item.
3. Press the [▲] or [▼] key to select the key number to be programmed,
and then press the [ENT/MENU] key.
4. Press the [▲] or [▼] key to select the desired menu item, then press the
[ENT/MENU] key.
5. Press the [▲] or [▼] key to select the desired setting.
6. Press the [ENT/MENU] key to store the new setting.
7. Press the [CLR/
9.1 CHANNEL SETUP
9.1.1 CHANNEL GROUP
This menu item enables changing the channel group.
Refer to the section "8.5 CHANNEL GROUP" for details.
9.1.2 WEATHER ALERT ( In USA and Canada only )
Enables/disables the NOAA Weather Alert function. The default setting is "OFF".
Press and hold [ ENT/MENU ]  "CHANNEL SETUP"  "WEATHER ALERT"
1.
2. Press the [▲] or [▼] key to select "ON" or
"OFF".
3. Press the [ENT/MENU] key to store the new
setting.
4. Press the [CLR/
9.1.3 SCAN MEMORY
Before scanning can begin, the desired scan channels must be programmed.
This selection allows channels to be stored to the scan memory.
Refer to section "8.9.1 PROGRAMMING SCAN MEMORY" for details.
9.1.4 SCAN TYPE
This selection is used to change the scan mode between "M-SCAN" ( Memory
Scan ) and "P-SCAN" ( Priority Scan ) . The default setting is "P-SCAN".
Refer to section "8.9.2 SELECTING SCAN TYPE" for details.
Page 28
] key to return to radio operation.
] key to return to radio operation.