Inserting/Connecting The Flight Battery - FMS 1086440 Notice D'emploi

Caution, important!
Before connecting the flight battery to the model, the transmitter must be taken into operation. Observe
that the control lever for the motor function is in the bottom position.
Install the flight battery (1) centred in the fuselage tip and fasten it with hook-and-loop tape (2). Connect it to the
model electronics via the plug connector (3) protected against polarity reversal.
The electronics now check the battery voltage and the position „motor off". After approx. 2 seconds, there will be a
sound sequence signalling readiness for operation of the model. The rudder, elevator, aileron as well as the motor
react to the movements of the control levers at the transmitter now. Regarding the flight controller, also observe the
notes in chapter „Programming the Flight Controller".

13. Inserting/Connecting the Flight Battery

Figure 9
59