Safety Information; General Information; Before Commissioning - FMS 1086440 Notice D'emploi

6. Safety Information

In case of damage caused by non-compliance with these operating instructions, the warranty/guarantee
will expire. We do not assume any liability for consequential damage!
We do not assume any liability for property damage and personal injury caused by improper use or non-
compliance with the safety instructions! In such cases the warranty/guarantee is voided.
Normal wear and tear and accident and crash damage (e.g. broken rotor or other broken parts) are also
excluded from the guarantee and warranty.
Dear customer, these safety instructions are not only for the protection of the product but also for your own
safety and that of other people. Therefore, read this chapter very carefully before taking the product into
operation!
a) General Information
Caution, important note!
Operating the model may cause damage to property and/or individuals. Therefore, make sure that you are
sufficiently insured when using the model, e.g. by taking out private liability insurance.
If you already have private liability insurance, verify whether or not operation of the model is covered by
your insurance before commissioning your model.
Note: In some countries you are required to have insurance for all model aircraft!
• The unauthorized conversion and/or modification of the product is inadmissible for safety and approval reasons
(CE).
• This product is not a toy and not suitable for children under 14 years of age.
• The product must not become damp or wet.
• If you do not have sufficient knowledge regarding handling of remote-controlled models, contact an experienced
model sportsman or model construction club.
• Do not leave any packaging material unattended. It may become a dangerous playing material for children.
• Should questions arise that are not answered by these operating instructions, contact us (for contact information,
see chapter 1) or another expert.
b) Before Commissioning
• Always switch on the transmitter first and then connect the flight battery to the plane model's electronics. Otherwi-
se, the model plane may show unpredictable responses and the rotor may start unintentionally!
• Check the functional safety of the model plane and remote control system. Watch out for any visible damage such
as defective plug connections or damaged cables. All moving parts at the flight model must run smoothly but must
not have any tolerance in the bearing.
• The flight battery required for operation must be charged according to the operating instructions.
• Always observe sufficient residual capacity for the transmitter batteries (battery tester). If the batteries are empty,
always replace the complete set, never individual cells only.
46