Elevator Function (Mode 2) - FMS 1086440 Notice D'emploi

c) Elevator Function (Mode 2)
If the control stick for the elevator function is moved down, the elevator must deflect to the top. The rear rudder edge
must be deflected upwards by approx. 8 - 10 mm. In flight, the landing gear is pressed downwards and the model
ascends.
If the control stick for the elevator function is moved up, the elevator must deflect downwards. The rear rudder edge
must be deflected downwards by approx. 8 - 10 mm. In flight, the landing gear is pressed upwards and the model
dives.
This control function is required to put the model into a normal light position if it wants to ascend too much due to a
control error or a gust of wind.
In operation in mode 1, the elevator control would not use the right, but the left control lever. For this, the
switch „Mode 1 / Mode 2" would have to be pushed and the transmitter converted mechanically. Contact a
specialist or specialist workshop for this.
64
Figure 14
Figure 15