If these parameters are not met in mains water, a specific filtration device must be
installed, always complying with current national and local regulations regarding
drinking water.
Once the water inlet and drain connections have been made, we will open the valve or
tap to fill the boiler.
ATTENTION!
This equipment is to be installed with adequate backflow protection to comply
with applicable federal, state or local codes.
8 - Start-up
Set the main switch to the "ON" position (I) and
automatically the machine will proceed to fill the boiler
to the set level. Once the filling process has been
completed, the water will be heated up to the working
temperature and pressure.
Pump pressure regulation: The pump is factory-set
to 9 bar pressure. If it is necessary to adjust it, proceed
as follows: Remove the plastic cap located on the side
panel of the machine, and with the help of a screwdriver,
turn the screw of the pump.
In a clockwise direction, the pressure is increased. Counter clockwise decreases the
pressure.
Expansion valve regulation: The expansion valve is a component that limits the
maximum working pressure of the machine. This pressure must never exceed 12 bar.
The valve is regulated at 11 bar in the factory. If you wish to regulate the valve, follow
these instructions: Place the filter holder with the blind filter in the coffee group. Start
the unit and adjust the pump to the pressure at which you want to regulate the valve,
and then turn the regulator of the valve until the water comes out through it. Once the
process is finished, re-regulate the pump up to 9 bars.
From this moment, it will be necessary to wait until the temperature of the coffee
groups reaches the set-point (showed in the specific display of each group dedicated
to the temperature in models ONE/PLUS) in order to start making coffee, and until the
temperature of the steam/hot water boiler reaches the set-pint one (the pressure gauge
14
MAN.31 V13 MANUAL BARISTA T 2023_EN_ES_DE_FR.indd 14
MAN.31 V13 MANUAL BARISTA T 2023_EN_ES_DE_FR.indd 14
0= OFF
l= ON
18/10/2023 11:23:26
18/10/2023 11:23:26