Publicité
Les langues disponibles
Les langues disponibles
If the time required to reach a first aid post exceeds
one hour, induce vomiting but in any case seek
medical attention.
After contact with skin, wash the affected part im-
mediately with soap and water, repeating the oper-
ation until completely clean.
In case of contact with eyes or ears, rinse the affect-
ed parts immediately with plenty of water and seek
medical advice immediately (first aid post), indi-
cating the cause and how the accident occurred.
After contact with clothes, remove contaminated
articles and wash immediately with plenty of water
and soap. Change the dirty clothes, which must be
washed as soon as possible. Avoid coolant spilling
or overflowing from the tank; if it comes into con-
tact with overheated engine parts it could cause a
fire with invisible flames.
If coolant is accidentally spilt, clean the affected
area thoroughly.
Always wear latex gloves to protect hands when
carrying out maintenance.
NOTE: an increase in the temperature causes the
coolant to increase in volume. The coolant has a
specific "fill level", see (FILL LEVEL).
There is an air gap between the "fill level" and a
completely full designed to allow the coolant vol-
ume to increase without danger of it leaking out.
NOTE: during refilling, do not exceed the "fill lev-
el". At the end of refilling, always close the filler cap
well.
KEEP OUT OF REACH OF CHILDREN. DISPOSE OF
THE COOLANT AT A SPECIAL WASTE COLLECTION
POINT.
CONTROL AND TOPPING UP
For the maintenance intervals, see (PERIODIC
MAINTENANCE CHARTS), under:
- coolant.
Do not use the vehicle if the coolant level is below
the minimum level.
For the type of coolant to be used, see (LUBRI-
CANTS) under:
- coolant.
Only use coolant of the specified type. If other
types are used, there is a build-up of mineral
salts that affect the efficiency of the cooling sys-
tem. To change the liquid, it is advisable to go to
a FANTIC MOTOR Dealer.
!
When the engine is hot the coolant
is under pressure and reaches a
high temperature. If the cap is ope-
ned there is the risk of burns to the
skin. ONLY remove the coolant cap
(1) when the engine is at ambient
temperature
- Make sure that the engine is cold.
- Place the vehicle on the stand.
- Keep the vehicle upright with both wheels resting
on the ground.
- Turn the handlebar to the left.
- Unscrew (by turning counter-clockwise) the filler
cap (1) by about one turn.
- Wait for a few seconds to allow any pressure in the
system to be released.
- Unscrew the filler cap (1) by turning counter
92
Publicité
