Publicité
Les langues disponibles
Les langues disponibles
ADJUSTING HYDRAULIC BRAKE
Standard setting:
- 15 clicks from fully closed.
To restore the standard setting, turn the adjusting
ring i n (+) direction as far as the fully closed posi-
tion and then turn back for the number of clicks in-
dicated above. To obtain smoother braking action,
turn the adjusting device in direction (-); reverse
the direction (+) to obtain harder braking action.
89
CHAIN
The vehicle is fitted with a chain of the stud link
type. When taking off and remounting the chain,
make sure that the spring of the stud is installed
with the open part facing in the opposite direction
to forward movement.
!
If the chain is excessively slack it
could come off the sprocket, caus-
ing accidents or serious damage to
the vehicle.
Regularly check the chain slack
and if necessary adjust the tension.
Only go to an authorised Dealer to
have the chain replaced.
Incorrect maintenance could lead to early wear
of the chain and damage the sprocket and the
gearing. Carry out maintenance more frequent-
ly if the vehicle is used in hard conditions or on
dusty or muddy roads. Take great care over ad-
justing, lubricating, cleaning and replacing the
chain.
CHAIN TENSIONING
- Stop the engine.
- Place the vehicle on the stand.
- Place the gear lever in neutral.
- Check that the up and down movement, midway
between sprocket and ring gear in the lower sec-
tion of the chain, is approx. 40 mm.
- Shift the vehicle forward to check the up and
down movement of the chain also in other posi-
tions; the slack must remain constant throughout
the entire rotation of the wheel.
If the slack is greater in certain positions this
means that there are crushed or bound links. In
this case consult a Dealer. If the slack is uniform
but greater or lower than 40 mm, adjust.
To avoid the risk of jamming, it is recommended
that the chain be well lubricated.
ADJUSTMENT
- Using the relative wrench, lock rotation of the
wheel pivot bolt (4).
- Loosen the wheel nut (3).
NOTE: for rear wheel truing there are reference
notches stamped on both ends of the fork arms.
Publicité
