SOLIS EASYVAC PLUS Mode D'emploi page 106

CLEAni n G A n D CA rE
s
To clean your vacuum-appliance, please proceed as follows:
1. Always first pull the plug out of the socket.
2. Never submerge the appliance in water or hold it under running water.
3. Do not use aggressive cleaning agents, solvents or abrasive materials for clean-
ing with appliance, these could damage the surfaces.
4. Wipe the appliance with mild cleaning agents and with a soft, damp cloth.
5. Leave the appliance to completely air dry, before storing or using the appliance.
6. The appliance must not be oiled.
• Note: The seals around the vacuum chamber should also be completely dry.
If you take them out for a thorough clean then put them back in place, then
they must be put back in exactly the same position so that no air can enter the
vacuum chamber.
P o W Er - C AbL E S to rA G E
If the appliance is not in use, the power cable should be rolled up and placed in
the cable compartment on the underside of the appliance. Never wrap the cord
around the appliance!
Stor in G th E A P PL i AnCE
s
• Caution: Before storing, always check that the lid of the appliance is not
locked shut! Otherwise the seals will become no longer airtight.
Store the appliance in a flat dark place, out of reach of children, at best in it's
original packaging. The vacuum sealer must rest on it's base and not lie on it's
side since this could cause damage to the appliance which would not be covered
by warranty.
The upper cover must remain open with the locking catches disengaged. Moreo-
ver, nothing should be placed on top of the appliance so that there is no pressure
on the seals. Seals are consumables and are not covered by warranty.
106