Mondolfo Ferro AAS 924 Manuel D'utilisation page 103

Setting the diameters (10"→20" or 14"→24") with an adjustment device is to be car-
ried out with the turntable completely stationary and without acting on any controls.
- The turntable clamps are opened and closed by
sequentially pressing the control pedal
- With the clamps fully closed, press the control pedal
slightly bringing it to the midway position
(Fig. 19a).
In this configuration it is possible to control clamp
opening with an operator present and then stop them
in the required position.
- If the rim blocks from the outside (Fig. 19b), pre-pos-
ition the clamping grippers using the diameter ref-
erences on the turntable plate and the red notch on
the clamp (Fig. 19c).
For example, Rim 18", pre-position the clamps aligning
them with the red notch with a value of 18".
- If the rim blocks from the inside (Fig. 19d), the
clamping grippers do not need to be pre-poisitioned.
The shape of the grippers themselves bring the rim
to be blocked into the correct position.
- Place the wheel (with the narrow shoulder of the
rim facing upwards) on the turntable,
- Push it downwards slightly and actuate the control
pedal to lock the wheel in position (fig.20).
- Press the pedal
AS 924 - AS 924 A Operator's Manual
CAUTION
to bring the column to the working position. (Fig.21).
.
19A
19b
19c
19d
UK
103