Hoisting/Handling; Installation Area - Mondolfo Ferro AAS 924 Manuel D'utilisation

4. HOISTING/
HANDLING
In order to remove the machine from the pallet,
hook it as shown in fig.6.
This hoisting point must be used whenever
you need to change the installation position
of the machine. Do not attempt to move the
machine until it has been disconnected from
the electricity and compressed air supply
systems.

4.1 INSTALLATION AREA

Install the machine in compliance with all the applicable safety standards, includ-
ing, but not limited to, those issued by OSHA.
IMPORTANT: for the correct and safe operation of the machine, the lighting level in the
place of use should be at least 300 lux.
IMPORTANT: Do not install the machine outdoors. It is designed to be used in closed,
covered areas.
RISK OF EXPLOSION OR FIRE. Do not use the machine in areas that could be ex-
posed to inflammable vapours (petrol, paint solvents, etc.).
Do not install the machine in a narrow area or below floor level
AS 924 - AS 924 A Operator's Manual
WARNING
WARNING
WARNING
DANGER
6
UK
91