Special Tools; Approved Uhp And Run Flat Tyre Demounting And Mounting Procedure; Safety Rules - Mondolfo Ferro AAS 924 Manuel D'utilisation

(fig.29).
- Press the pedal
column to the "resting" position.
- Release the wheel and remove it from the
tyre changer

Special tools

To make it easier to mount/demount low
profile tyres, it is recommended that the bead
presser gripper is used (optional accessory
supplied on request).
8.7 APPROVED UHP AND RUN FLAT TYRE DEMOUNTING AND
MOUNTING PROCEDURE
For a detailed description of the mounting/demounting procedure of the UHP and RUN
FLAT tyres, please refer to the instructions in the manual prepared by WDK (German Tyre
Industry Association).
8.8. INFLATING THE TYRES
8.8.A. SAFETY RULES
108
to bring the
DANGER
• E XPLOSION HAZARD
• D o not exceed the pressure recommended by
the tyre manufacturer.
• Never mismatch tyre size and rim size.
• Pay careful attention to any damage to the tyre
• During inflation operations, assume a position
which is outside of the vertical cylinder volume
occupied by the wheel.
AS 924 - AS 924 A Operator's Manual
29