Levelling Of The Appliance; Assembly Diagram - Palazzetti Ecomonoblocco MX 25:9F Notice D'installation Et D'entretien

7.3 levelling of the appliance

To adjust the final height of the Ecomonoblocco
(height fire plane of the cladding) it is sufficient
to act on the adjusting screws on the legs. Adjust
the screws (Fig. 11: A-adjustment screw, b-fire
bed height), until the marble cover profile is
brought onto the Ecomonoblocco to the required
height with respect to the cladding, making sure
that the base of the fire box is level.
A

7.4 Assembly diagram

In Fig. 12 there is an example of an assembly
diagram.
A) Chimney flue
b) External air intake
c) Heat recovery grate
D) Counter-hood and
structure
E) Flue gas duct
F) Inspection panel
G) Air recirculation grate
H) Minimum distance 5 mm between cladding
and Ecomonoblocco
Correct installation of the fume duct between
the Ecomonoblocco and the fireplace must be
watertight, sealing all the linking joints (A - Fig.
12) with material suitable for high temperatures.
If the Ecomonoblocco is installed on a fireplace
previously used by other fire boxes, it is necessary
to carry out thorough cleaning to avoid abnormal
functioning and to prevent possible igniting of
any unburned products that may be deposited
on the inner walls of the same.
The installation requires the installation of a heat
recovery grate as close as possible to the ceiling
(approximately 20 cm) (c - Fig. 12).
004778930 - 06/12/2021
ITALIANO ENGLISH
5 mm
B
Fig. 11
fireproof load-bearing
DEUTSCH FRANÇAIS
The provision of an inspection panel (F - Fig. 12)
with minimum dimensions 300x300 mm at the
height of the gearmotor, required for models
with automatic door opening, and on moving
parts to facilitate maintenance.
Incorrect installation can compromise
the safety of the appliance.
The lining must be made of fireproof
material.
C
D
E
H
G
Product images are for illustrative
purposes only
The electrical system, if present, must
be earthed and equipped with an earth
leakage circuit breaker in accordance
with current legislation.
The flue gas evacuation duct must
be equipped with its own earth
connection.
ESPAÑOL
A
F
B
Fig. 12
49