Corghi EM 9250 CompactLine Manuel D'utilisation page 85

When the measurement is stored, the value of the distance acquired by the machine will
remain visible on the left display:
- if only one measurement is taken, the machine interprets the presence of a rim with balanc-
ing using a clip weight on both sides (Dynamic Balancing Programme);
- moving the arm to the rest position, the machine will set up for the manual WIDTH entry;
- in this phase, it is possible to perform an additional acquisition of the rim diameter and
distance.
- Measure the width of the rim using the calliper
provided (fig.12).
- Modify the width value displayed by pressing the
buttons until the desired value is
set.
The WIDTH can be set in millimetres or the values
already set can be converted from inches to mil-
limetres by pressing the
EM 9250 CompactLine Operator's manual
button.
11b
UK
12
85