Information Regarding Machine Demolition; Environmental Information - Corghi EM 9250 CompactLine Manuel D'utilisation

These components can be cleaned using a brush previously dripped in environmentally
friendly solvents.
Handle cones and flanges carefully so as to avoid accidental dropping and subsequent
damage that would affect centring accuracy.
After use, store cones and flanges in a place where they are suitably protected from dust
and dirt.
If necessary, use ethyl alcohol to clean the display panel.
Perform the calibration procedure at least once every six months.
INFORMATION REGARDING
MACHINE DEMOLITION
If the machine is to be scrapped, remove all electrical, electronic, plastic and metal parts
and dispose of them separately in accordance with current provisions as prescribed by law.

ENVIRONMENTAL INFORMATION

The disposal procedure described below only applies to machines with the symbol of
the waste bin with a bar across it on their data plates.
This product may contain substances that can be hazardous to the environment and to
human health if it is not disposed of properly.
The following information is therefore provided to prevent the release of these substances
and to improve the use of natural resources.
Electrical and electronic equipment must never be disposed of in the usual municipal
waste but must be separately collected for their proper treatment.
The crossed-out bin symbol, placed on the product and on this page, reminds the user
that the product must be disposed of properly at the end of its life.
In this way it is possible to prevent that a non specific treatment of the substances con-
tained in these products, or their improper use, or improper use of their parts may be
hazardous to the environment or to human health. Furthermore, this helps to recover,
recycle and reuse many of the materials contained in these products.
Electrical and electronic manufacturers and distributors set up proper collection and
treatment systems for these products for this purpose.
Contact your local distributor to obtain information on the collection procedures at the
end of the life of your product.
When purchasing this product, your distributor will also inform you of the possibility to
return another end-of-life piece of equipment free of charge as long as it is of equivalent
type and had the same functions as the purchased product.
120 EM 9250 CompactLine Operator's manual