Wilo CronoLine-IL-E Notice De Montage Et De Mise En Service page 132

en
Access disable menu
11.6 Operating instructions
11.6.1 Adjusting the setpoint
1.0.0.0
12.3
2200
1.0.0.0
1800
Fig. 39: Entering the setpoint
11.6.2 Changing to menu mode
2 s
ON
1
2.0.0.0
12.3
Fig. 40: Standard menu mode
2 s
ON
1
5.0.0.0
12.3
Fig. 41: Service mode menu
6.0.0.0
E000
Fig. 42: Fault event mode menu
132 Installation and operating instructions • Wilo-CronoLine-IL-E, Wilo-CronoTwin-DL-E, Wilo-CronoBloc-BL-E • Ed.01/2024-02
• <7.0.0.0>: Access disable
The "access disable" feature is available when DIP switch 2 is set to ON. The menu cannot be
reached via normal navigation.
Pressing the operating button activates or deactivates the access disable feature. The selec-
tion is confirmed by pressing the operating button.
The setpoint can be adjusted on the status page.
• Turn the operating button.
The display changes to menu <1.0.0.0> and the setpoint starts flashing. Turning the oper-
ating button increases or decreases the setpoint.
RPM
• To confirm the change, press the operating button.
The new setpoint will be accepted and the display will return to the status page.
RPM
To change to the menu mode:
2 s
• While the display is showing the status page, press the operating button for
2 seconds (except in event of a fault).
Standard behaviour
The display changes to menu mode. Menu <2.0.0.0> is displayed.
Service mode
±
When service mode is activated (using DIP switch 1), menu <5.0.0.0> is displayed first.
Fault event
±
In the event of a fault, menu number <6.0.0.0> is displayed
±