Wilo CronoLine-IL-E Notice De Montage Et De Mise En Service page 131

"Selection/setting" menu element
±
11.5.3 Display error page
E000
Fig. 38: Error page (error status)
11.5.4 Menu groups
Basic menu
Info menu
Service menu
Error acknowledgement menu
Installation and operating instructions • Wilo-CronoLine-IL-E, Wilo-CronoTwin-DL-E, Wilo-CronoBloc-BL-E • Ed.01/2024-02
The adjacent "Selection/Setting" symbol does not appear on the display. In these instruc-
tions, this symbol marks menu items that allow a selection or setting to be made.
If a "Selection/Setting" menu item is selected, pressing the operating button switches to
editing mode.
In editing mode, the adjustable value flashes. Turn the operating button to adjust the value;
press the operating button again to save the set value.
In some menus, the display briefly shows the "OK" symbol after you press the operating but-
ton to confirm the entry
If an error occurs, the display changes from the status page to the error page. The display
shows the letter "E" and the three-digit error code, separated by a decimal point.
E.025
• <1.0.0.0>: Setpoint settings
• <2.0.0.0>: Operating mode setting
• <3.0.0.0>: "Pump on/off" setting
The menus show settings that may need to be changed during normal operation of the
pump.
• <4.0.0.0>: Pump parameter display
The menu <4.0.0.0> and its sub-menu elements show measuring data, device data, operat-
ing data and current statuses.
• <5.0.0.0>: Access to pump parameter settings
The menu <5.0.0.0> and its sub-menu elements provide access to basic system settings for
commissioning. The sub-elements are write-protected as long as service mode is not activ-
ated.
• <6.0.0.0>: Error acknowledgement
If an error occurs, the display shows the error page. Pressing the operating button takes you
from the error page to the error acknowledgement menu. After a waiting period has elapsed,
pending fault messages can be acknowledged. For additional information, see "Acknow-
ledging errors" chapter.
For additional information, see "Faults, causes and remedies" chapter
CAUTION
Risk of material damage!
Incorrect changes to settings can lead to pump operation errors, which in
turn can lead to pump or system damage.
• Settings in service mode should only be made during commissioning
and only by qualified personnel.
CAUTION
Risk of material damage!
Acknowledging faults without eliminating their cause can cause further
faults. Material damage may occur to the pump or system.
• Only acknowledge errors after they have been rectified.
• Only allow qualified personnel to rectify faults.
• If in doubt, consult the manufacturer.
en
131