Publicité
Les langues disponibles
Les langues disponibles
Mode 2 memorisation – with this memorisation, the commands that can
be sent by pressing the A, B or C buttons on the DS1 selector switch are
those listed in table 14.
In Mode 2 each key requires its own memorisation phase.
To memorise DS1:
01. Press P2 (fig. 42) on the control unit, the same number of times as
your desired command, according to Table 14 (e.g. 3 times for the
"Open Only" command).
02. Check that LED P1 emits a number of quick flashes which are equal
to the selected command.
03. Within 10 s, type in the factory combination 11 (or the secret combi-
nation, if the factory combination has been changed), and press the
desired key for memorisation on the selector switch for at least 3 s.
If the procedure was memorised correctly, the P2 LED will flash
slowly 3 times.
04. After 10 s the memorisation phase terminates automatically.
Deletion – if the DS1 selector switch is memorised in Mode 1, one dele-
tion phase is sufficient and at step 3 any key, A, B or C, can be pressed.
If the selector is memorised in Mode 2 a deletion phase is necessary for
each key stored.
To delete DS1:
01. Press the P2 key (fig. 42) on the control unit and hold it down.
02. Wait until the LED P2 lights up, within three seconds.
03. Type in the factory combination 11 (or the secret combination, if the
factory combination has been changed), and press the desired key
for deletion on the selector switch for at least three seconds. If can-
cellation was successful the LED P2 will flash quickly five times.
04. If there are other selector switches to delete, keeping P2 depressed,
repeat step 3 within another 10 seconds; otherwise, the deletion will
stop automatically.
For more information on the DS1 selector switch, refer to the product
instruction manual, or visit www.niceforyou.com
42
GTX4
CL9WKA
C
PH100W
Led "A"
Led "B"
PH100W
Led "A" Led "B" key "T" Jumper "J"
10.5 - TROUBLESHOOTING
Table 15 contains instructions to help you solve malfunctions or errors
that may occur during the installation stage or in case of failure.
10.6 - DIAGNOSTICS AND SIGNALS
A few devices give out special signals that allow you to recognise the
operating status or possible malfunctions.
10.6.1 - Photocells
The photocells include LEDs that allow you to check their operational
state at any time. For the led "A" (fig. 42) see Table 16. For the led "B"
(fig. 42) see Table 13.
10.6.2 - Flashing indicator
The flashing indicators include LEDs that allow you to check their opera-
tional state at any time. For the led "A" (fig. 42) see Table 17. For the led
"B" (fig. 42) see Table 18.
During the manoeuvre the flashing indicator flashes once every second.
When something is wrong the flashes are more frequent (every half sec-
ond); the light flashes twice with a second's pause between flashes, see
Table 19.
A
B
Key "T"
Jumper "J"
Key
tasto
P1
Led
P1
Key
tasto
P2
Led
P2
Key
tasto
P3
Led
P3
tasto
Key
P4
Led
P4
English – 25
Publicité
