Publicité
Les langues disponibles
Les langues disponibles
Ø6 mm
x4
29
Ø6 mm
x4
Ø6 mm
x4
Ø6 mm
x4
1
2
3
Ø6 mm
x4
14 – English
30
Ø6 mm
x4
Ø6 mm
x4
Ø6 mm
Ø6 mm
x4
1
2
3
1
6.3 - POWER SUPPLY CONNECTION
WARNINGS!
– The PVC power cable is suitable for indoor installations. For
installation outdoors, you must protect the entire cable with a pro-
tective duct. Alternatively, you can replace the cable with one of
type H07RN-F.
– The final connection of the automation to the electrical mains or
substitution of the cable supplied must be performed exclusively
by a qualified and expert electrician, in compliance with local safe-
ty standards and the following instructions.
• For operational and programming tests of the automation, use
the cable supplied, inserting the plug into an electrical socket. If the sock-
et is far from the automation, use a suitable extension lead.
• For the test and commissioning phase of the automation you
must connect the control unit permanently to the mains power supply,
replacing the supplied cable with another of suitable length. To make the
connection between the cable and the gearmotor control unit, proceed as
described below:
WARNING:
Provide a device inside the electricity supply line that ensures complete
disconnection of the automation mechanism from the grid. The dis-
connection device must have contacts with an opening distance large
enough to permit complete disconnection under the conditions sanc-
tioned by overvoltage category III, in accordance with installation regula-
tions. The device ensures quick, safe disconnection from the power sup-
ply if needed, and must therefore be positioned in view of the automation
mechanism. If, on the other hand, it is located in a position which is not
visible, there must be a system for preventing accidental or unauthorized
reconnection with the power grid to prevent this risk. The disconnection
device is not supplied with the product.
01. Make sure that the gearmotor plug is not plugged into the wall socket.
02. Disconnect the power supply terminal electrical cable from the gear-
motor;
03. Loosen the collar found under the terminal and remove the electric
cable. Replace it with a permanent power supply cable;
04. Connect the electric cable to the gearmotor power supply terminal;
05. Tighten the collar to secure the electric cable.
x4
Publicité
