Measurement Reference; Distance Measurement - TOOLCRAFT LDM 50 P Mode D'emploi

Measurement reference

• As per the factory default setting, measurement are taken beginning
from the back of the device.
• Push the button
following measurement references are available:
•
•
•
•
•
•

10. Distance measurement

1. If the target laser (B) is not activated, push the button ON (C) to
activate the laser.
2. Point the laser at a right angle at the target and hold the device as
still as possible.
3. Push the button ON. Shortly, a beep sounds and the reading is
shown on the display.
40
(D) to change the measurement reference. The
Zero point: Back of the device
The device length is included in the measurement.
Zero point: End piece (K) on the back
Fold out the end piece on the back.
The device length and end piece length are included
in the measurement.
Zero point: Front of the device