Recalling Saved Measurements - TOOLCRAFT LDM 50 P Mode D'emploi

5. When the real-time measurement approaches the set distance, the
output alarm signals at a higher repetition rate. The repetition rate is
at its highest when the real-time measurement and the set distance
are equal.
The repetition rate increases when you approaches a
multiple of the set distance.
For instance, if you have set a distance of 2 m,
the repetition rate will increase when the real-time
measurement is 4 m, 6 m, 8 m, 10 m, etc.
6. Push the button ON to interrupt measurement. At this point, you can
also reset the distance using the buttons + and - as described above.
7. Push the button ON to continue measurement.

19. Recalling saved measurements

• The last 50 measurements are saved automatically.
• Once all 50 memory slots are used, the oldest measurement is
erased and the newest measurement is saved to slot 50.
To recall saved measurement values, push the button + (H) in
•
standby mode to toggle through memory slots in ascending order.
Push the button - (E) to toggle through memory slots in descending
•
order.
• The memory slot (4) is shown at the top of the display.
50