Settings - TOOLCRAFT LDM 50 P Mode D'emploi

The signal strength indicator shows with which speed
and precision the surface reflects the signal. The
more bars, the higher the speed and precision of
measurement.
3. If necessary, push the button OFF (F) to deactivate the target laser.
4. Push and hold the button OFF for approx. two seconds to turn off
the device.
The target laser will be deactivated automatically after
30 seconds of inactivity.
The entire device turns off automatically after 3 minutes
of inactivity.

9. Settings

Unit
• The default measurement unit setting is in meters.
Push and hold the button UNIT (G) approx. 1 second to change the
•
unit.
• The corresponding indicator is displayed right next to the
measurement value.
• The following units are available:
Length
Area
Volume
Meter Foot
m
m²
m³
Inch
ft in
ft² ft
2
ft³ ft
3
0'00" 1/16
0'00" 1/16
ft
2
ft
3
39