Measuring Function; Area Measurement - TOOLCRAFT LDM 50 U Notice D'emploi

1. If the stakes are being set, N1 or N2 appears on the screen.
2. Enable the dyna-measuring function. (Refer to chapter 11.)
3. During the measurement, N1 or N2 appears with an arrow guiding
you to move in the correct direction.
4. The product alerts you by beeping when you are approaching the
stakes (0.5 m from the stakes).

13. Measuring function

Area Measurement

1. Press once to enter area measuring.
Standby Screen
2. Press
3. Follow the instructions on main screen to measure width and length.
4. Once you finish all instructions, area is shown on sub-screen.
5. To change display unit, press
44
to enable laser beam.
Area Measuring Instructions
Area Measuring Screen
.