Allmand NIGHT-LITE GR Serie Manuel D'utilisation page 20

18
A
B
Rotating The Light Tower
WARNING
Failure to tighten the light tower locking knob may cause
the light fixtures to swing inadvertently, especially in
windy conditions or during transport, and could result in
death or serious injury. Always tighten the tower locking
knob securely after turning the light tower.
CAUTION
Rotating the light tower will cause the light fixtures to
swing, and could result in minor to moderate injury. Be
careful to rotate the tower slowly, and be aware of the
light fixtures while rotating the tower.
1. Shut down the engine. See Operating the Engine.
2. Loosen the light tower rotation locking knob (A,
Figure 19).
3. Use the handles (B, Figure 19) to rotate the light
tower in the desired direction.
4. Tighten the light tower locking knob.
5. When lighting operations are complete, rotate the
light tower to the transport position, with the fixtures
facing straight back toward the rear of the light tower
trailer. Tighten the light tower rotation locking knob.
20
19
B
A
Raising and Lowering the Light Tower
DANGER
Electrocution Hazard
Raising the light tower in the presence of electrical
power lines will result in death or serious injury. Always
check overhead wires and obstructions before raising or
lowering the light tower.
WARNING
Rollover Hazard
Before raising, lowering or operating the tower lights,
the trailer must be set up, leveled and stabilized. See
Leveling and Stabilizing the Light Tower.
WARNING
Crush Hazard
Standing under the light tower while raising or lowering
could result in death or serious injury. Make sure that
there are no persons near the light tower when raising or
lowering the light tower.
Raising the Light Tower - Manual Winch (Standard)
1. Shut down the engine. See Operating the Engine.
Wait 10 minutes for the lights to cool.
2. Before raising the light tower, adjust the tower lights
to the desired work position. See Adjusting the
Lights.
3. Turn the winch handles (A, Figure 20) until the tower
is fully raised. Do not overturn the handles.
www.allmand.com