Allmand NIGHT-LITE GR Serie Manuel D'utilisation page 23

5. Adjust the light fixtures to the transport position. See
Adjusting the Lights.
6. Make sure the engine compartment cover is closed
and latched.
7. Retract the outriggers. See Leveling and Stabilizing
the Light Tower Trailer.
8. The unit is now ready for transport. See
Transporting.
Emergency Stop
The unit has an emergency stop that will immediately
shut the entire unit down in case of an emergency.
To Engage:
• Push the emergency stop (A, Figure 25).
To Disengage:
• Pull the emergency stop.
Make sure that you address the issue that caused the
emergency before you operate the unit again.
Do not use the emergency stop to shut down the unit
during normal operation. See Unit Shutdown.
25
A
Maintenance
WARNING
Operating or towing a machine with worn, damaged
or missing parts could result in death or serious injury.
Replace worn, damaged or missing parts immediately. Do
not operate or tow this machine until all worn, damaged
or missing parts have been replaced, and the machine
operates correctly.
WARNING
Shock Hazard
Batteries present a risk of electric shock and high short-
circuit current. Disconnect the black negative (-) battery
cable before you do maintenance. Failure to do so could
result in death or serious injury.
Before you do maintenance, see Safety.
Correct maintenance of the equipment is important
for safe operation. Use the following maintenance
procedures in addition to those scheduled by your shop
equipment maintenance schedule.
Where equipment is operated under severe conditions
(very dusty, extreme heat or cold, etc.), maintenance
should be done more frequently.
Engine
For engine service intervals and other recommendations
specific to this light tower unit refer to Specifications.
Refer to the Engine Operator's Manual for all other
scheduled engine maintenance procedures.
Engine Oil Drain
The unit is equipped with a remote engine oil drain (A,
Figure 26). To drain the engine oil:
1. Put an approved container below the oil drain.
2. Remove the oil drain plug and open the oil drain
valve underneath the engine.
3. Let the engine oil drain fully into the approved
container. Dispose of used engine oil according to
local, state, province and/or federal rules.
4. Replace the oil drain plug and close the oil drain
valve.
5. Change oil filter as needed. Refer to Specifications.
6. Add oil to the engine. Refer to Specifications.
26
A
en
23
English