Allmand NIGHT-LITE GR Serie Manuel D'utilisation page 22

22
A
B
Auxiliary AC Outlets
Auxiliary AC outlets (A, B, and C Figure 23) are located
on the right panel near the rear side of the unit. Each
outlet is protected by a spring-loaded cover.
Note: Outlets may differ according to model.
Power is supplied to the outlets only when the engine is
running and the main circuit breaker (D, Figure 24) is in
the ON position.
Note: The electrical system is designed with a delay after
the engine starts before the lights and auxiliary AC outlet
will operate.
The top and lower left outlets are protected by dedicated
circuit breakers (E and F Figure 24) found on the control
panel, and lower right outlet is protected by the main
circuit breaker.
If a Breaker Trips
1. Disconnect the load from the outlet.
2. Shut down the engine.
3. Wait 10 minutes for the generator to cool down.
4. Correct the load problem.
5. Start the engine.
6. Reset the breaker.
Note: Be sure to also check the GFCI breaker on the
GFCI outlet (if equipped), and reset if necessary.
7. Reconnect the load.
8. If the problem persists, see Troubleshooting.
22
23
A
B
24
D
Unit Shutdown
WARNING
Do not remove the wheel chocks from the front and back
of the wheels until the light tower trailer is connected to
the tow vehicle and ready to be transported. Doing so
could result in death or serious injury.
Once lighting operations are complete at the work site,
shut down the unit:
1. Shut down the engine. See Operating the Engine.
2. Wait 10 minutes for the lights to cool.
3. Lower the light tower. See Raising And Lowering
the Light Tower.
4. Rotate the light tower to the transport position. See
Adjusting the Lights.
C
F
E
www.allmand.com