MINN KOTA TERROVA Manuel Du Propriétaire page 9

MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to the centerline of the boat as
possible. Make sure the area under the mounting location is clear to drill holes and install
nuts and washers. Make sure the motor rest is positioned far enough beyond the edge of the
boat. The motor must not encounter any obstructions as it is lowered into the water or raised
into the boat when stowed and deployed. Consider a quick release or adapter bracket with
the installation of your motor. To view a list of accessories, please visit minnkotamotors.com.
TOOLS AND RESOURCES REQUIRED
• #3 Phillips Screwdriver
• Drill
• 9/32" Drill Bit
INSTALLATION
INSTALLING THE TERROVA
1
a. Place the mount on an elevated, level surface such
as a workbench or the tailgate of a pickup. The
motor, as removed from the box, should be in the
stowed position.
b. Remove the four sideplate screws using a #3 Phillips
Screwdriver. Two of these screws will be located on
each side of the mount.
NOTICE: This motor weighs approximately 65lbs.
We recommend having a second person help with
the installation.
©2023 Johnson Outdoors Marine Electronics, Inc.
• 7/16" Box/Open End Wrench
• 9/16" Box/Open End Wrench
• Pliers or Vice Grip
INSTALLING THE TERROVA
• A second person to help
with the installation
1b
Deployed Deployed
View accessories
available for your
trolling motor at
minnkotamotors.com.
• Flat-blade Screwdriver
• Awl or similar Marking Tool
Sideplate Screw Sideplate Screw
Stowed Stowed
minnkotamotors.com | 9