MINN KOTA TERROVA Manuel Du Propriétaire page 11

5
ITEM(S) NEEDED
#4 x 6
g. When the motor is in the deployed position, make
sure that the Shaft is 1-1/2" out past the Gunwale of
the boat. The lower unit, when stowed and deployed
must not encounter any obstructions.
h. Check to be sure that the mount is level. Use the
Rubber Washers (Item #4) provided to create a level
surface if necessary.
6
i. With an Awl or similar tool, mark all six mounting
holes in the Base Extrusion.
j. Drill through the deck of the boat using a 9/32" Drill
Bit on the marked locations.
©2023 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE TERROVA
Gunwale Gunwale
1-1/2" 1-1/2"
Minimum Minimum
Drilling Locations Drilling Locations
Drilling Locations Drilling Locations
Shaft Shaft
Base Extrusion Base Extrusion
minnkotamotors.com | 11