MINN KOTA TERROVA Manuel Du Propriétaire page 36

INSTALLING THE PROP
2
ITEM(S) NEEDED
#12 x 1
b. Take the Drive Pin (Item #9) and slide it through the
Hole in the Armature Shaft. Position the Drive Pin
horizontally by grasping the Armature Shaft and
rotating it with the Drive Pin in place.
c. Align the Propeller (Item #12) so it is also horizontal
and parallel with the Drive Pin. Slide the Propeller
onto the Armature Shaft and Drive Pin until it is
seated against the lower unit.
d. Install the Prop Washer (Item #10) and the Prop Nut
(Item #11) onto the end of the Armature Shaft.
3
e. Holding the end of the Armature Shaft with a Flat
Blade Screwdriver, tighten the Prop Nut with a 9/16"
Box End or Open End Wrench.
f. Tighten the Prop Nut 1/4 turn past snug to
25-35 in-lbs.
CAUTION
Do not over-tighten as this can damage the prop.
36 | minnkotamotors.com
#10 x 1 #11 x 1 #9 x 1
2b
Drive Pin Drive Pin
Prop Washer Prop Washer
2c
Prop Nut Prop Nut
Prop Washer Prop Washer
Propeller Propeller
Armature Armature
Shaft Shaft
Propeller Propeller
Prop Nut Prop Nut
Propeller Propeller
Drive Pin Drive Pin
©2023 Johnson Outdoors Marine Electronics, Inc.