MINN KOTA TERROVA Manuel Du Propriétaire page 35

6
i. Look at the placement of the Cable Ties and make
sure that at least 2 Cable Ties are present on the
Accessory Cables after they exit the Coil Cord.
If additional Cable Ties are needed, is may be
necessary to place the motor back into the deployed
position to add additional Cable Ties at an increment
of approximately 4 inches past the last Cable Tie.
j. If no additional Cable Ties are needed, make sure
to properly reconnect any Accessory Cables that
may have been disconnected while winding the
Accessory Cables into the Coil Cord.
Installing the Prop
1
CAUTION
Disconnect the motor from the battery before
beginning any prop work or maintenance.
a. While holding the Shipping Spacer with a pliers
or vise grip, remove the Prop Nut, Red Shipping
Washer, Prop Washer and Spacer, being careful
not to lose the Drive Pin. Reuse the Prop Nut, Prop
Washer and Drive Pin to attach the Propeller.
NOTICE: The Shipping Spacer and Red Shipping
Washer are for shipping purposes only and must be
discarded. The Red Shipping Washer will rust if used
to attach the Propeller.
©2023 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE PROP
Accessory Cables Accessory Cables
Tied Together Tied Together
Cable Cable
Tie Tie
Coil Coil
Cord Cord
Prop Prop
Drive Drive
Washer Washer
Pin Pin
Prop Prop
Nut Nut
Shipping Shipping
Spacer Spacer
(discard) (discard)
Red Red
Shipping Shipping
Washer Washer
(discard) (discard)
First Cable First Cable
Tie past Coil Tie past Coil
Cord Cord
Second Second
Cable Tie Cable Tie
past Coil past Coil
Cord Cord
Mount Mount
minnkotamotors.com | 35