Télécharger Imprimer la page

MINN KOTA TERROVA Manuel Du Propriétaire page 32

Masquer les pouces Voir aussi pour TERROVA:

Publicité

Les langues disponibles

Les langues disponibles

SECURING ACESSORY CABLES
1
a.
Confirm all Accessory Cables are connected to
an output device as desired. With the motor in
the deployed position, locate the Advanced GPS
Ethernet Connector below the Control Head.
b.
Starting just below the Control Head, take both the
Accessory Cables and make sure they are free from
the Coil Cord and parallel to each other. Run them
from the Control Head to the Mount keeping them
straight and parallel the entire length.
2
ITEM(S) NEEDED
c.
Starting approximately 4 inches below the
Control Head, take a Cable Tie (Item #16) and
place it around the Accessory Cables. The Cable
Tie should be around the Ethernet Cable and Sonar
Cable but not the Coil Cord.
NOTICE:
Do NOT secure the Cables to the Coil
Cord. ONLY secure the Cables with the Cable Ties
to each other.
d.
Secure the Cable Tie around the Cables until it is
fingertip tight. Do not over-tighten the Cable Tie as it
will cause damage to the Cables.
CAUTION
Do not over-tighten the Cable Ties as it may damage the wires.
32 | minnkotamotors.com
#16 x 10
1b
Sonar Cable
Sonar Cable
Advanced
Advanced
GPS Ethernet
GPS Ethernet
Connector
Connector
Coil
Coil
Cord
Cord
Mount
Mount
Ethernet
Ethernet
Cable
Cable
Ethernet
Ethernet
Cable
Cable
Control
Control
Head
Head
Approximately
Approximately
4 inches
4 inches
Cable Tie
Cable Tie
Sonar
Sonar
Cable
Cable
©2023 Johnson Outdoors Marine Electronics, Inc.

Publicité

loading