MINN KOTA TERROVA Manuel Du Propriétaire page 13

9
o. Replace the four sideplate screws using a #3 Phillips
Screwdriver. Two of these screws will be located on
each side of the mount.
Installing the Foot Pedal
1
ITEM(S) NEEDED
#13 x 5
a. Take the Foot Pedal (Item #EE) and turn it over.
Put a Foot Pedal Pad (Item #13) in each of the
pad locations.
NOTICE: The pads are recommended when using
the Foot Pedal on non-carpeted surfaces.
b. Locate the 7-pin Foot Pedal Connection on the Foot
Pedal and the Power Connection on the Motor.
Align the pins of the Foot Pedal Connection to the
matching socket end of the Power Connection.
Firmly push the Plug together.
NOTICE: The connectors are keyed to prevent
reversed installation.
©2023 Johnson Outdoors Marine Electronics, Inc.
#EE x 1
INSTALLING THE FOOT PEDAL
Foot Pedal Foot Pedal
Bottom Bottom
Foot Pedal Foot Pedal
Pad Placement Pad Placement
Foot Pedal Foot Pedal
Connection Connection
Sideplate Screw Sideplate Screw
Power Connection Power Connection
from Motor from Motor
minnkotamotors.com | 13