MINN KOTA TERROVA Manuel Du Propriétaire page 28

ADVANCED GPS NAVIGATION
3
d. If NO Sonar is present, take the cable, leading with
the Receptacle, and fish it through the center of
the Coil Cord starting at the end of the Coil Cord
attached to the Mount and working up towards
the Control Head. Allow enough slack in the cable
to attach the Receptacle to the Advanced GPS
Ethernet Connector.
NOTICE: Minn Kota recommends routing the Ethernet
Cable through the Coil Cord when making the Ethernet
connection. The cable will be installed from the Mount
to the Control Head through the Coil Cord and parallel
to the Advanced GPS Cable. Bypassing the Coil Cord
when routing the Ethernet Cable is not recommended.
e. Verify the length of your motor shaft to determine if
Critical Cable Routing applies to your trolling motor.
If the trolling motor shaft is 60 inches or more, adjust
the Ethernet Cable to exit the Coil Cord three coils
before the Motor Base. Review the "Critical Cable
Routing" section of this document for more details.
NOTICE: CRITICAL CABLE ROUTING. On motors with a
shaft 60" or more, accessory cables must exit the Coil
Cord leaving three or more open coils between where
the cables exit and the motor base, as assembled by
the factory. Routing the cables in any other manner
will not allow the motor to stow properly. Please see
the "Critical Cable Routing" and "Securing Accessory
Cables" sections of this document for details.
28 | minnkotamotors.com
Control Head Control Head
3d
Ethernet Cable Ethernet Cable
Advanced Advanced
GPS GPS
Ethernet Ethernet
Connector Connector
Mount Mount
Shafts 60 inches or more
Shaft Shaft
Built-in Built-in
MEGA MEGA
Down Down
Imaging Imaging
At least At least
3 Coils 3 Coils
Motor Motor
Base Base
Receptacle Receptacle
Ethernet Cable Ethernet Cable
Critical Critical
Cable Cable
Routing Routing
Foot Pedal Foot Pedal
Power Power
Power Connector Power Connector
Leads Leads
Shafts less than 60 inches
Shaft Shaft
Built-in Built-in
MEGA MEGA
Down Down
Imaging Imaging
Motor Motor
Base Base
©2023 Johnson Outdoors Marine Electronics, Inc.