MINN KOTA TERROVA Manuel Du Propriétaire page 17

The integrated design of the Dual Spectrum CHIRP transducer protects it in the lower unit of the trolling motor from underwater hazards
and prevents tangles and damage to the transducer cables. In certain situations, air bubbles may adhere to the surface of the Dual
Spectrum CHIRP transducer and affect the performance. If this happens, simply wipe the surface of the transducer with your finger.
Considerations for Connecting and Routing Dual Spectrum CHIRP
If Dual Spectrum CHIRP is pre-installed on your trolling motor, one Dual Spectrum CHIRP accessory cable will exit the base of the Control
Head and run down the center of the Coil Cord. Dual Spectrum CHIRP requires cables to be connected to an output device such as a
Humminbird® fish finder. The Dual Spectrum CHIRP cable that exits the Coil Cord is "Apex and Solix Ready." Connecting the trolling motor
equipped with a Dual Spectrum CHIRP transducer to a compatible fish finder gives you a 2D sonar view of what is happening directly
below your trolling motor. To determine if your fish finder is compatible with Dual Spectrum CHIRP, please visit
check compatibility. The Dual Spectrum CHIRP cable from the trolling motor may be plugged directly into a Solix or Apex, directly into an
Extension Cable or directly into a Humminbird® Helix Adapter Cable.
EXTENSION CABLES - The Dual Spectrum CHIRP cable from the trolling motor may not be long enough to reach your fish finder. If the
cable length does not reach the desired fish finder installation location, extension cables are available. A 10-foot extension cable
(EC M3 14W10 - 10' transducer extension cable -
cable - 720106-2) are available from humminbird.com. Both the 10-foot and 30-foot extension cables also come "Apex and Solix Ready."
The Extension Cables may plug directly into a Solix or Apex or directly into a Helix Adapter Cable.
HUMMINBIRD HELIX ADAPTER CABLES
will allow the connection of any compatible Humminbird® Helix fish finder. The 490537-2 MKR-MI-1 is used on Helix 8, 9, 10, 12 and 15
G2N models and newer. The 490518-1 MKR-MDI-2 is used for Helix 7 G3, G4, G3N and G4N models. The Helix adapter cables will plug
directly into the Helix fish finder.
OTHER FISH FINDER ADAPTER CABLES
adapter cables online at minnkotamotors.com.
Dual Spectrum CHIRP Connections
Control Head Control Head
Dual Spectrum Dual Spectrum
Advanced GPS Advanced GPS
Ethernet Ethernet
Connector Connector
Coil Coil
Cord Cord
Mount Mount
©2023 Johnson Outdoors Marine Electronics, Inc.
720106-1) and a 30-foot extension cable
- If connecting to a Humminbird® Helix fish finder, an adapter cable accessory is included that
- If connecting to other fish finders on the market, check for compatibility or any required
CHIRP CHIRP
Dual Dual
Spectrum Spectrum
CHIRP CHIRP
Foot Pedal Foot Pedal
Power Connector Power Connector
Power Leads Power Leads
DUAL SPECTRUM CHIRP
minnkotamotors.com
(EC M3 14W30 - 30' transducer extension
Extension Extension
Cable Cable
(if needed) (if needed)
Helix Adapter Helix Adapter
to
Directly Directly
to Solix to Solix
or Apex or Apex
Cable Cable
(provided) (provided)
To Helix To Helix
minnkotamotors.com | 17