MINN KOTA TERROVA Manuel Du Propriétaire page 45

For safety reasons, disconnect the motor from the battery/batteries when the motor is not in use or while the battery/batteries are being
charged. If the motor control is left on and the propeller rotation is blocked, severe motor damage can result.
AutoPilot
The AutoPilot Indicator is located on the Indicator Panel on the Mount. It is illuminated green
illuminated when AutoPilot is not engaged.
Stow Deploy Lever
The Stow Deploy Lever is located at the top of the mount. The Stow Deploy Lever functions to unlatch the Fall Away Ramps which rotate to
guide the Lower Unit. The Stow Deploy Lever is actuated by pressing it down.
STOWING AND DEPLOYING THE MOTOR
To Deploy the Motor
Loosen the Depth Collar then push firmly down on the Stow
Deploy Lever. Slide the motor forward, out from the Fall Away
Ramp. Lower the motor to the desired depth. Make sure it clicks
into a secure, vertical position. Once at the desired depth, slide the
Depth Collar against the Steering Housing and tighten.
To Stow the Motor
Loosen the Depth Collar and depress the Stow Deploy Lever. Raise
the motor by pulling up on the Shaft or Control Head. Pull the
motor toward the stern until it rests securely on the Fall Away Ramp
and the Fall Away Ramps captures the Lower Unit. Slide the Depth
Collar down and secure it against the top of the Steering Housing to
secure the motor in place and prevent accidental deployment.
PUSH-TO-TEST BATTERY METER
This motor is equipped with a Push-to-Test Battery Meter. The
LED located on the Indicator Panel on the Mount of the motor. The
Battery Meter provides an accurate display of the remaining charge
in the battery. It is only accurate when the motor is off. The meter
reads as follows:
• One light indicates recharge.
• Two lights indicate low charge.
• Three lights indicate good charge.
• Four lights indicate full charge.
Moving parts can cut or crush. Keep fingers clear of all moving parts.
©2023 Johnson Outdoors Marine Electronics, Inc.
STOWING AND DEPLOYING THE MOTOR
CAUTION
When stowing or deploying the motor, keep fingers clear of all
hinge and pivot points and all moving parts.
The Control Head will create a pinch point if the Depth Collar
Knob is loosened and the Control Head slides to the top of the
Depth Collar. Grasp the Shaft and prevent it from sliding all the
way down to prevent the pinch point.
Practice proper ergonomics when stowing and deploying the
motor to prevent injury.
Indicator Indicator
Panel Panel
WARNING
when AutoPilot is engaged and it is not
WARNING
WARNING
BATTERY METER
TEST WITH MOTOR OFF
TEST
TERROVA
Push-to-Test Push-to-Test
Battery Meter Battery Meter
minnkotamotors.com | 45