MINN KOTA TERROVA Manuel Du Propriétaire page 24

BUILT-IN MEGA DOWN IMAGING
5
ITEM(S) NEEDED
i. If installing directly to a Helix Adapter Cable, align
the pins on the accessory cable or extension cable
with the receptacle on the Helix Adapter Cable
(Item #17 or 18). Notice the keyed connectors.
Tighten the Collar from the accessory cable or
extension cable to secure the connection.
NOTICE: The 490537-2 MKR-MI-1 (Item #17) is a
Helix Adapter Cable used on Helix 8, 9, 10, 12 and 15
G2N models and newer. The 490518-1 MKR-MDI-2
(Item #18) is a Helix Adapter Cable used for Helix 7 G3,
G4, G3N and G4N models. Both cables are included.
j. If the Helix Adapter Cable will be attached directly to a
Humminbird
Keyed Connection on the back of the fish finder.
NOTICE: If connecting to other fish finders on the
market, check for compatibility or any required adapter
cables online at minnkotamotors.com.
k. If your trolling motor has more than one external
connector for an output device, complete the
connection for that specific output and then follow
the instructions for "Securing Accessory Cables" to
complete the output cable installation.
24 | minnkotamotors.com
#17 or 18 x 1
Helix, plug it in the Helix Adapter Cable
®
5i
Fourteen Pin Fourteen Pin
Connector Connector
Collar Collar
Built-in MEGA Down Imaging Built-in MEGA Down Imaging
Accessory Cable from Trolling Accessory Cable from Trolling
Motor or Extension Cable Motor or Extension Cable
5j
Helix Adapter Helix Adapter
Cable Cable
NOTICE: If unsure of what features your trolling motor may
be installed with that require connection to an output device,
please review the "Identifying Trolling Motor Features And
Their Associated Cables" section in this document.
Receptacle Receptacle
Helix Adapter Cable Helix Adapter Cable
Adapter Adapter
Cable Keyed Cable Keyed
Connector Connector
Plug into Plug into
Helix Fish Helix Fish
Finder Finder
©2023 Johnson Outdoors Marine Electronics, Inc.