MINN KOTA TERROVA Manuel Du Propriétaire page 18

DUAL SPECTRUM CHIRP
All Dual Spectrum CHIRP Terrova motors are equipped with an internal bonding wire. Incorrect rigging will cause sonar interference and
can damage your trolling motor, electronics, and other boat accessories. To minimize trolling motor interference, ensure that the fish
finder and trolling motor are powered by separate batteries. Please refer to the "Battery & Wiring Installation" and "Motor Wiring Diagram"
sections of this manual for correct rigging instructions.
The Dual Spectrum CHIRP cables are shielded to minimize interference. To protect this shielding, the cables should not be pulled tight
against sharp angles or hard objects. If using cable ties, do not over-tighten. Any excess cable should be bundled in a loose loop of no
less than 4" in diameter. The connection cable should be routed to the fish finder following Minn Kota recommendations on routing the
cables to optimize mobility and maximize functionality. Follow the instructions below for completing all connections and then follow the
instructions for "Securing Accessory Cables" to complete the output cable installation.
Failure to follow the recommended wire routing for installed features, if equipped, may cause damage to the product and void your
product warranty. Route cables away from pinch points or other areas that may cause them to bend in sharp angles. Routing the cables
in any way other than directed may cause damage to the cables by being pinched or severed. Do not over-tighten the cable ties as it may
damage the wires.
1
NOTICE: Your fish finder should be turned off
until this procedure is complete.
a. Place the motor in the deployed position.
b. Locate the Fourteen Pin Connector on the end of the
Dual Spectrum CHIRP accessory cable. The cable
will exit the base of the Control Head and run down
the center of the Coil Cord.
c. Determine if the Plug on the end of the Dual
Spectrum CHIRP accessory cable will be attached
directly to:
1) a Humminbird
2) a Dual Spectrum CHIRP Extension Cable,
3) a Helix Adapter Cable or a compatible fish finder
adapter cable.
18 | minnkotamotors.com
CAUTION
® Solix or Apex fish finder,
Coil Coil
Cord Cord
Dual Dual
Spectrum Spectrum
CHIRP CHIRP
Mount Mount
Foot Pedal Foot Pedal
Power Connector Power Connector
Fourteen Pin Fourteen Pin
Connector Connector
Power Power
Leads Leads
©2023 Johnson Outdoors Marine Electronics, Inc.