MINN KOTA TERROVA Manuel Du Propriétaire page 48

INSTALLING AN EXTERNAL TRANSDUCER
INSTALLING AN EXTERNAL TRANSDUCER
An external transducer is not included with your trolling motor. An external transducer can be installed onto motors that have Advanced
GPS Navigation or motors that do not have a built-in transducer. Installing an external transducer is not recommended for motors with
Built-in MEGA Down Imaging.
1
a. Mount the External Transducer according to
directions provided with the transducer.
b. Leave enough slack in the Transducer Cable
between the Lower Unit and Control Head to allow
the motor to properly stow and deploy.
c. Use two tie wrap cables to secure the Transducer
Cable to the Shaft just below the Control Head.
d. Run the Transducer Cable through the Coil Cord to
the power supply.
CAUTION
Failure to follow the recommended wire routing for the
Advanced GPS Navigation and External Transducer Cables
may cause damage to the product and void your product
warranty. Take care to test the length and placement of
cable to be sure that there is enough slack where needed
and that cables are free of being entangled in moving parts.
Routing the cables in any way other than directed may cause
damage to the cables by being pinched or severed.
48 | minnkotamotors.com
Control Head Control Head
Coil Cord Coil Cord
Transducer Transducer
Cable Cable
©2023 Johnson Outdoors Marine Electronics, Inc.
Tie Wrap Tie Wrap
Cable Cable
Slack Slack
Tie Wrap Tie Wrap
Cable Cable
Lower Unit Lower Unit
External Transducer External Transducer