Télécharger Imprimer la page

MINN KOTA TERROVA Manuel Du Propriétaire page 23

Masquer les pouces Voir aussi pour TERROVA:

Publicité

Les langues disponibles

Les langues disponibles

2
d.
Verify the length of your motor shaft to determine if
Critical Cable Routing applies to your trolling motor.
If the trolling motor shaft is 60 inches or more,
adjust the Built-in MEGA Down Imaging Cable to
exit the Coil Cord three coils before the Motor Base.
Review the "Critical Cable Routing" section of this
document for more details.
NOTICE:
CRITICAL CABLE ROUTING. On motors with a
shaft 60" or more, accessory cables must exit the Coil
Cord leaving three or more open coils between where
the cables exit and the motor base, as assembled by the
factory. Routing the cables in any other manner will not
allow the motor to stow properly. Please see the "Critical
Cable Routing" and "Securing Accessory Cables"
sections of this document for details.
3
e.
If installing directly to a Solix or Apex, the connection
will be flat on the back of the fish finder display.
f.
Align the pins on the Accessory Cable with the
receptacle on the fish finder. Notice the keyed
connections. Tighten the Collar from the accessory
cable to secure the connection. Once directly
installed to the Solix or Apex, the connection
is complete.
4
g.
If installing directly to a Built-in MEGA Down
Imaging Extension Cable, align the pins on the
accessory cable with the receptacle on the
extension cable. Notice the keyed connectors.
Tighten the Collar from the accessory cable to
secure the connection.
h.
If the Built-in MEGA Down Imaging Extension Cable
will be attached directly to a Humminbird
or Apex, the connection will look exactly like the
installation directly into a Humminbird Solix or Apex
fish finder.
NOTICE:
A 10-foot extension cable
(EC M3 14W30 - 30' transducer extension cable -
©2023 Johnson Outdoors Marine Electronics, Inc.
Shafts 60 inches or more
Shaft
Shaft
Solix
®
Imaging Accessory Cable
Imaging Accessory Cable
(EC M3 14W10 - 10' transducer extension cable -
720106-2) are available from humminbird.com.
BUILT-IN MEGA DOWN IMAGING
Built-in
Built-in
MEGA
MEGA
Down
Down
Imaging
Imaging
At least
At least
3 Coils
3 Coils
Motor
Motor
Base
Base
Fourteen Pin Connector
Fourteen Pin Connector
Built-in MEGA Down
Built-in MEGA Down
Imaging Accessory Cable
Imaging Accessory Cable
from Trolling Motor
from Trolling Motor
Fourteen Pin
Fourteen Pin
Connector
Connector
Collar
Collar
Built-in MEGA Down
Built-in MEGA Down
from Trolling Motor
from Trolling Motor
720106-1) and a 30-foot extension cable
Shafts less than 60 inches
Shaft
Shaft
Built-in
Built-in
MEGA
MEGA
Down
Down
Imaging
Imaging
Motor
Motor
Base
Base
Solix or Apex
Solix or Apex
Fish Finder
Fish Finder
Receptacle
Receptacle
Built-in MEGA Down Imaging
Built-in MEGA Down Imaging
Extension Cable
Extension Cable
minnkotamotors.com | 23

Publicité

loading