MINN KOTA TERROVA Manuel Du Propriétaire page 26

ADVANCED GPS NAVIGATION
GPS Ethernet Connection
Control Control
Head Head
Advanced Advanced
GPS GPS
Ethernet Ethernet
Connector Connector
Coil Cord Coil Cord
1
NOTICE: Your fish finder should be turned off
until this procedure is complete.
a. Place the motor in the deployed position.
b. Locate the Eight Pin Advanced GPS Ethernet
Connector below the Control Head. The Advanced
GPS Ethernet Connector will exit the base of the
Control Head and will rest just below the Control
Head next to the Coil Cord.
NOTICE: Terrova trolling motors with Advanced GPS
Navigation may also be equipped with Sonar. Sonar is
pre-installed from the factory and may be either Dual
Spectrum CHIRP or Built-in MEGA Down Imaging. If
equipped with Sonar, a Sonar Cable will be present
below the control head and run through the middle of
the Coil Cord. Review the "Identifying Trolling Motor
Features and Their Associated Cables" section of this
document to identify and learn more about Sonar.
26 | minnkotamotors.com
Power Leads Power Leads
Foot Pedal Foot Pedal
Power Connector Power Connector
Ethernet Cable Ethernet Cable
(provided) (provided)
Advanced Advanced
GPS GPS
Ethernet Ethernet
Connector Connector
Coil Cord Coil Cord
Helix Adapter Cable Helix Adapter Cable
(provided if needed) (provided if needed)
Advanced GPS Advanced GPS
Ethernet Ethernet
Connector Connector
Sonar Sonar
Cable Cable
(if equipped) (if equipped)
Power Leads Power Leads
Foot Pedal Foot Pedal
Power Connector Power Connector
©2023 Johnson Outdoors Marine Electronics, Inc.
To Helix To Helix
Directly Directly
to Solix to Solix
or Apex or Apex
Eight Pin Eight Pin
Connector Connector