MINN KOTA TERROVA Manuel Du Propriétaire page 33

3
e. Follow the Cables from the Control Head to the
Mount and place additional Cable Ties every 4
inches around the Cables after the first Cable
Tie. The number of Cable Ties needed will vary
depending on the length of your trolling motor Shaft.
NOTICE: If additional Cable Ties are needed, a
Service Assembly (#2996300 TIE WRAP ASM,
60") is available from the Parts Ordering Portal
at minnkotamotors.com.
NOTICE: Secure the Cable Ties fingertip tight.
It is recommended to have them ONLY tight
enough so that they do not slide around on the
Connection Cables and hold the cables together.
4
f. Continue placing Cable Ties around the Accessory
Cables until there are two Cable Ties in place past
the end of where the Coil Cord enters the Mount.
©2023 Johnson Outdoors Marine Electronics, Inc.
SECURING ACESSORY CABLES
Control Control
Head Head
First First
Cable Tie Cable Tie
Shaft Shaft
Cable Tie Cable Tie
Cable Tie Cable Tie
Mount Mount Ethernet Cable Ethernet Cable
or Ethernet or Ethernet
Extension Cable Extension Cable
Approximately Approximately
4 inches 4 inches
Approximately Approximately
4 inches 4 inches
Approximately Approximately
4 inches 4 inches
Coil Coil
Cord Cord
First Cable First Cable
Tie past Coil Tie past Coil
Cord Cord
Approximately Approximately
4 inches 4 inches
Approximately Approximately
4 inches 4 inches
Approximately Approximately
4 inches 4 inches
Sonar Sonar
Cable Cable
Second Second
Cable Tie Cable Tie
past Coil past Coil
Cord Cord
Mount Mount
minnkotamotors.com | 33
Cable Cable
Tie Tie