Connection Of The Camera To The Power Supply; Connection Of The Camera's Power Line In 12Vdc And 24Vac (Without Power Supply); Connection Of The Camera's Power Line In 120Vac And 230Vac (Without Power Supply) - Videotec MAXIMUS MHX Manuel D'instructions

7.3.5 Connection of the camera to the
power supply
Incorrect wiring can irreparably damage
the camera.
To connect the power supply use the removable
connectors supplied.
Perform proper wiring according to the camera's
required supply voltage.
Maximum power consumption for camera and lenses:
13W
Power cables to be used: AWG16 (1,5mm²).
7.3.5.1 Connection of the camera's power
line in 12Vdc and 24Vac (without power
supply)
In these versions the input voltage will be
the voltage of the camera/lens.
Remove the removable connector from the board
(J7). Carry out the wiring between the removable
connector and the camera's power supply terminals.
Re-insert the connector into the board.
J7
Fig. 26
MNVCMHX_1432_EN
7.3.5.2 Connection of the camera's power
line in 120Vac and 230Vac (without power
supply)
In these versions the input voltage will be
the voltage of the camera/lens.
Remove the removable connector from the board
(J6). Carry out the wiring between the removable
connector and the camera's power supply terminals.
Re-insert the connector into the board.
J6
Fig. 27
25