GSi AUDIOSTAR PRO Manuel D'instructions page 88

NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects, and people.
(a)
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless)
telephones and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast
cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to
fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field
strength in the location in which the system is used exceeds the applicable RF compliance level
above, the system should be observed to verify normal operation. If abnormal performance is
observed, additional measures may be necessary, such as reorienting or relocating the system.
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
(b)
NOTICE: There are no deviations from the collateral standard and allowances uses
NOTICE: All necessary instruction for maintaining compliance regarding EMC can be found
in the general maintenance section in this instruction. No further steps required.
D-0131088 Rev C, 2022-07
GSI AudioStar Pro Instructions for Use
Interference may occur
near equipment marked
with the following symbol:
Page 83 of 84