Publicité
Les langues disponibles
Les langues disponibles
SPECIFICATIONS
Programming Defaults
Default
Parameter
Value
Lag Start
3 s
Delay
Lag Stop Hz
35.0 Hz
Lag Stop
5 s
Delay
Lead/Lag ID
N/A
Alternation
Timer
Alternation
24 h
Timer
Analog Out-
Speed
put Selection
Run/Stop
Run Open
Input
Coast (Sub)
Stop Mode
Decel (Cen)
Diagnostics
Stabilizer
Disabled
Mode
Stabilizer
10.0
Gain 1
Stabilizer
2.0
Gain 2
Stabilizer
50.00
Frequency 1
Stabilizer
120.00
Frequency 2
Stabilizer Bus
Enabled
Prediction
Protections Setup
Output Phase
Open Fault
Enabled
Enable
Output Phase
50
Open Level
Input Phase
Enabled
Open
50
Units
Range
DIP
Switch
Seconds • 0 to 600
• Low
Frequency
Hz
Limit to High
Frequency
Limit
Seconds • 0 to 600
N/A
• N/A
• Disabled
N/A
• Timer
Hours
• 0.1 to 168 Hrs
• Speed
N/A
• Analog
Yes
Repeater
• Run Open
N/A
• Run Closed
• Coast
N/A
• Decelerate
• Enabled
N/A
• Disabled
• Stabilizer
N/A
Gain 2 to 50.0
• 0.0 to
N/A
Stabilizer
Gain 1
Hz
• 1.00 to 50.00
• 50.00 to
Hz
120.00
• Enabled
N/A
• Disabled
• Enabled
N/A
• Disabled
%
• 5 to 50
• Enabled
N/A
• Disabled
Set Parameter via:
FE
Progra
Connect
mming
App
No
No
Yes
No
No
Yes
No
No
Yes
No
No
No
No
No
Yes
No
No
Yes
No
Yes
No
Yes
Yes
No
No
Yes
No
No
Yes
No
No
Yes
No
No
Yes
No
No
Yes
No
No
No
No
No
Yes
No
No
Yes
No
No
Yes
No
No
Yes
Change
while
Description
Running
Timer to regulate how quickly lags
No
are added in multidrive operation
Speed at which Lead drive must run
No
before turning off lags
Timer to regulate how quickly lags
No
are removed in multidrive operation
N/A
Indicates Lead or Lag status
Enables or disables alternation of the
Lead drive in multidrive configura-
No
tion. This balances the load amongst
drives.
Timer to rotate the Lead status
No
among drives in multidrive configu-
ration.
Sets analog output to repeat input
pressure transducer signal or the
No
speed of the drive as a 4-20mA sig-
nal.
Changes the polarity of the Run/
Stop Input on the drive. This can be
No
changed using the Menu screen and
buttons or the mobile app.
Sets the stopping operation of the
drive to either decelerate using the
Yes
drive to control slowdown or allow
the pump and motor to coast.
No
Enables or disables stabilizer mode
Sets the gain of the stabilizer at low
No
frequencies
Sets the gain of the stabilizer at high
No
frequencies
Sets the frequency at which Gain 1 is
No
active for the stabilizer
Sets the frequency at which Gain 2 is
Yes
active for the stabilizer
Enables or disables DC bus predic-
No
tion feature
Enables or disables output open
No
phase protection
Adjusts sensitivity level of open
No
phase protection
Enables or disables Input open phase
No
protection
Publicité
