Publicité
INSTRUCTIONS FOR USE
3.
To remove a support from the Allen Advance Table, slide
the blue clamp to the unlocked position. When unlocked,
only the red area will show on the pin.
Chest Support
1.
Put the chest support in position on the Rail Top at a
location dependent on the patient's gender:
• Female—install the support so that it will be above
the breasts and below the clavicle paying close
attention to avoid the brachial plexus.
• Male—install the pad so that it will be across the
nipple area.
NOTE: When the support is installed, the indent should be
toward the foot end of the Allen Advance Table.
2.
Attach the Velcro® straps to hold the support in position.
3.
Install an Allen® Ultra Comfort™ Cover on to the support. Make sure that—
• The foam side of the cover is on the outside.
• The cover completely covers the blue material of the support.
NOTE: Allen® Support Pads are designed to work with Allen® Ultra Comfort™ Covers only.
Head Plate
1.
Put the head plate in position on the Rail Top at a location
to support the patient's head.
2.
Attach the Velcro® straps to hold the head plate in
position.
3.
Install the foam head block on to the head plate.
NOTE: The Allen® Head Plate is designed to work with the
Allen® Foam Head Block only.
Document Number: 80028190
Version: E
Page 37
English
Issue Date: 16 MAY 2022
Ref Blank Template: 80025117 Ver. F
Publicité
