Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 40

A B
I I n n d d i i c c a a t t o o r r
A Bed motion lock
B Fowler 30°+
Low height
C
D Brake
Bed exit (optional)
E
Bed zero (optional i i B B e e d d Awareness)
F
Siderail (optional i i B B e e d d Awareness)
G
H Power
EN 36
C D
F F i i g g u u r r e e 2 2 4 4 – – F F o o o o t t b b o o a a r r d d L L E E D D i i n n d d i i c c a a t t o o r r s s
E F
L L E E D D i i l l l l u u m m i i n n a a t t e e s s a a m m b b e e r r
Bed motion lock is activated or when the patient
control (Fowler, Gatch, bed up/down) lock buttons
are activated
Fowler 30°+ is locked. The LED will blink amber if:
• i i B B e e d d Awareness system is on
• Fowler 30°+ is being monitored and the Fowler
goes below 30 degrees
• Fowler 30°+ is turned off
Bed is in low height. The LED will blink amber if:
• i i B B e e d d Awareness system is on
• Low height is being monitored
• Bed is not in low height
Brake is set, and will blink amber if the brake is not
set
Bed exit is armed. The LED will blink amber if:
Bed exit is turned off while the i i B B e e d d Awareness
•
system is turned on
Bed exit alarms while monitored by the i i B B e e d d
•
Awareness system
Bed zero is successful
i i B B e e d d Awareness system is on. The LED will blink
amber when siderail state has changed.
Green when bed has power
G H
3005-009-005 Rev AA.1