Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 49

2. Scroll to S S c c a a l l e e U U n n i i t t s s .
3. Press the E E n n t t e e r r button (F) ( Menu display (page 39)).
4. Select a scale unit (Figure 48).
5. Press the E E n n t t e e r r button (F) ( Menu display (page 39)).
To cancel the request, press the E E x x i i t t button (E) ( Menu display (page 39)).
C C h h a a n n g g i i n n g g t t h h e e b b a a c c k k l l i i g g h h t t i i n n t t e e n n s s i i t t y y
The backlight changes the LED backlight intensity for all control panels (operator control panel, patient control panel, and
footboard control panel).
N N o o t t e e - - The default backlight intensity is low.
Five settings are available for the control panel LED intensity.
S S e e t t t t i i n n g g
1
2
3
4
5
N N o o t t e e - - The nurse call LED backlight on the patient control panel shows the patient which button to press to contact the
nurse's station. Turning the nurse call LED backlight light off may compromise this ability in a darkened room.
To change the backlight LED intensity:
1. Press the M M e e n n u u button (A). See Menu display (page 39).
2. Scroll to B B a a c c k k l l i i g g h h t t .
3. Press the E E n n t t e e r r button (F). See Menu display (page 39).
4. Select a backlight intensity (Figure 49).
5. Press the E E n n t t e e r r button (F). See Menu display (page 39).
3005-009-005 Rev AA.1
F F i i g g u u r r e e 4 4 8 8 – – S S c c a a l l e e U U n n i i t t s s
L L E E D D i i n n t t e e n n s s i i t t y y
Off
Low
Medium
High
Nurse call only
F F i i g g u u r r e e 4 4 9 9 – – B B a a c c k k l l i i g g h h t t
45 EN