Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 39

• bed exit indicator LED on the footboard LED indicator flashes
• sound alarm is triggered
• selected zone on the footboard control panel flashes
• status alert is displayed on the display screen
To disarm bed exit, press and hold the A A r r m m / / D D i i s s a a r r m m button again (D). See Footboard control panel - C C h h a a p p e e r r o o n n e e bed exit
with zone control (option) (page 33).
F F o o o o t t b b o o a a r r d d L L E E D D i i n n d d i i c c a a t t o o r r s s
B
A C D E
I I n n d d i i c c a a t t o o r r
A Bed motion lock
B Fowler 30°+
C Patient control Fowler lock
D Patient control Gatch lock
Patient control bed height lock
E
F Zone 1
G Zone 2
H Zone 3
3005-009-005 Rev AA.1
F F i i g g u u r r e e 2 2 3 3 – – F F o o o o t t b b o o a a r r d d L L E E D D i i n n d d i i c c a a t t o o r r s s
F G H
L L E E D D i i l l l l u u m m i i n n a a t t e e s s a a m m b b e e r r
Bed motion lock is activated or when the patient
control (Fowler, Gatch, bed up/down) lock buttons
are activated
Fowler 30°+ is locked. The LED will blink amber if:
• i i B B e e d d Awareness system is on
• Fowler 30°+ is being monitored and the Fowler
goes below 30 degrees
• Fowler 30°+ is turned off
The patient control Fowler lock is on
The patient control Gatch lock is on
The patient control bed height lock is on
Bed exit is on and zone 1 is active. The LED will blink
amber if a bed exit event occurs.
Bed exit is on and zone 2 is active. The LED will blink
amber if a bed exit event occurs.
Bed exit is on and zone 3 is active. The LED will blink
amber if a bed exit event occurs.
35 EN