Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 14

C C u u s s t t o o m m e e r r W W L L A A N N e e n n v v i i r r o o n n m m e e n n t t
Supported wireless vendors
Access point (AP) types
Channel width
Channel utilization
Signal strength range (minimum)
Minimum SNR
Priority queuing
Client exclusion
Client load balancing
Max number of SSIDs
Authentication timeouts
N N o o t t e e - - A transmit power asymmetry problem may arise at the edges of virtual cell coverage if an APs transmit power is
higher than the Stryker Wireless Client device (~6 mW 2.4 GHz or 12 mW 5 GHz). The received signal strength indicator
(RSSI) of the Stryker i i B B e e d d Wireless Client on the AP must be verified. The device should never drop below an RSSI of -75
dBm on the AP.
EN 10
Cisco, Aruba
Controller-based or autonomous
2.4 GHz: 20 MHz
5 GHz: 20/40 MHz
Consistently less than 30%
2.4 GHz: -67dBm +0/-8dBm
5 GHz: -67dBm +0/-8dBm
Minimum 20dB
Prioritized over best effort traffic
Disabled
Disabled
5
Add session timeout of at least 24
hours
R R e e q q u u i i r r e e d d
Yes
Yes
Yes
Recommended
Yes
Yes
Recommended
Recommended
Recommended
Recommended
Recommended
3005-009-005 Rev AA.1