Stryker S3 MedSurg Bed with StayPut Frame Mode D'emploi page 46

F F i i g g u u r r e e 3 3 6 6 – – W W e e i i g g h h t t l l o o g g
M M e e a a s s u u r r i i n n g g w w e e i i g g h h t t g g a a i i n n o o r r l l o o s s s s
The gain or loss function compares the initial patient weight to the current patient weight. It then displays the weight the
patient has gained or lost since the initial patient weight reading.
To enable gain or loss:
1. Press the M M e e n n u u button (A) (Figure 33).
2. Scroll to G G a a i i n n / / L L o o s s s s .
3. Press and hold the E E n n t t e e r r button (F) (Figure 33) (Figure 37) until R R e e l l e e a a s s e e B B u u t t t t o o n n appears (Figure 38).
F F i i g g u u r r e e 3 3 7 7 – – H H o o l l d d t t o o e e n n a a b b l l e e
F F i i g g u u r r e e 3 3 8 8 – – R R e e l l e e a a s s e e B B u u t t t t o o n n
4. Release the E E n n t t e e r r button.
N N o o t t e e - - Do not touch the product when you measure weight gain or loss (Figure 39).
F F i i g g u u r r e e 3 3 9 9 – – D D o o n n o o t t t t o o u u c c h h b b e e d d
A confirmation notification indicates that enabling G G a a i i n n / / L L o o s s s s was successful.
The base measurement is the initial patient weight registered when you enable G G a a i i n n / / L L o o s s s s . The weight difference between
the base weight and the weight gained or lost is displayed on the bottom right hand corner (Figure 40).
F F i i g g u u r r e e 4 4 0 0 – – B B a a s s e e a a n n d d g g a a i i n n / / l l o o s s s s w w e e i i g g h h t t m m e e a a s s u u r r e e m m e e n n t t
N N o o t t e e - - If the weight gained or lost exceeds 99.9 lb (45.3 kg), E E r r r r o o r r – – . . - - appears on the display (Figure 41).
EN 42 3005-009-005 Rev AA.1